"Velvet" hand cream

This hand cream protects the hands with a velvety, waxy film that does not feel dull or greasy. A high proportion of consistency-giving agents and a low fat content ensure a protective, soft skin feel.

Emulblend Bee and Waxblend Hydrosoft protect the skin and provide an enveloping finish. Lipoblend Hydrosoft and jojoba esters keep the skin supple for a long time and protect against dehydration.

 

innometics-handcreme-velvet

Difficulty:  ⭐⭐⭐ advanced

Production time: ⏱ approx. 40 minutes


Ingredients in percent

A1   7 Propanediol
  3 Instabond Velvet
A2 72,6 distilled water
B     3 Emulblend Bee
  3 Cetearyl Alcohol
  3 Lipoblend Hydrosoft
  2 Shea Butter
  0,5 Waxblend Hydrosoft
  3 Vegemelt
  0,5 Anti-Ox Emulsion
C      2 Preblend Aqua
  0,1 Calcium Pantothenate
  0,5 Jojoba Ester Gel
q.s. Citric acid solution

 

Yields 100%

 

Instructions:

  1. Weigh out A1 and stir.
  2. Weigh out A2.
  3. Add A1 to A2 while stirring to prevent Instabond Velvet from clumping.
  4. Heat A to approx. 60 degrees.
  5. Weigh out B and heat to approx. 70 degrees until all components have melted.
  6. Add B (oil phase) to A (water phase) and stir in.
  7. Homogenize for 1 minute with a mixer.
  8. Allow to cool to approx. 40 degrees while stirring occasionally.
  9. Add C and stir in.
  10. Briefly homogenize again with the mixer.
  11. Adjust the pH value to approx. 5.2 using a citric acid solution.

 

Recommendation:

We recommend filling the hand cream into an airless dispenser or a pump bottle so that fewer germs enter your hand cream through clean dispensing, allowing you to use it safely for a long time.

innometics-ruehrutensilien-set


Leave a comment

Please note, comments must be approved before they are published


FAQ: Frequently Asked Questions about "Velvet" hand cream

Wie fühlt sich die Handcreme „Velvet“ an?

Sie hinterlässt einen samtig-wachsigen Schutzfilm, der weder stumpf noch fettig wirkt. Dafür sorgen ein hoher Anteil an Konsistenzgebern und ein niedriger Fettanteil.

Welche Rohstoffe schützen die Hände?

Emulblend Bee und Waxblend Hydrosoft schützen die Haut und geben ein einhüllendes Finish. Lipoblend Hydrosoft und Jojobaester halten die Haut geschmeidig und schützen vor Austrocknung.

Wie aufwendig ist die Herstellung?

Das Rezept ist als fortgeschritten (drei Sterne) eingestuft und dauert etwa 40 Minuten. Die Wasserphase wird auf etwa 60 Grad, die Fettphase auf etwa 70 Grad erwärmt. Nach dem Emulgieren und Homogenisieren gibst du Phase C bei etwa 40 Grad dazu und stellst den pH-Wert auf etwa 5,2 ein.

In welche Verpackung fülle ich die Handcreme?

Am besten in einen Airless- oder Pumpspender. So entnimmst du die Creme hygienisch, es gelangen weniger Keime hinein und sie bleibt länger haltbar. Mehr dazu im Beitrag Haltbarkeit und Stabilität von Kosmetikprodukten.