Hand Balm "Protection"

This special hand balm contains a high moisture content, a low amount of oil, and a high proportion of wax. It quickly forms a protective, non-greasy film that shields the skin from external stressors such as frequent washing or irritants.

 

innometics-hand-balm-protection

Difficulty level:  ⭐⭐ medium 

Production time: ⏱ approx. 40 minutes

Careblend Supreme creates a well-adhering, protective texture thanks to its cationic properties. Hydrolyzed sunflower wax and SoftEster form a flexible film that protects the skin like an invisible shield. 

Hydromollient and Waxblend Hydrosoft ensure a soft skin feel and have a moisture-binding effect. Niacinamide provides lasting reinforcement of the skin barrier by stimulating the body's own ceramide synthesis.

 

Raw materials in percent

 



%
A1
Propanediol green 7
Instabond Velvet 3
A2
Citric acid crystalline 0.1
Niacinamide 1
Distilled water 70.8
A3
Careblend Supreme 3
Cetearyl alcohol 5



Hydromollient 2
Liposens 2
Waxblend Hydrosoft 0.5
Hydrolyzed sunflower wax 0.4
Cocoa butter 1
Soft Ester 2.5
Anti-Ox Emulsion 0.5



C
Preblend Easy 1
"White Lagoon" fragrance 0.2

Total 100

 

Instructions

Weigh out A1 and stir.

Weigh out A2 and stir.

Add A3.

Heat phase A to approx. 70°C and stir repeatedly until everything has melted.

Weigh out phase B and heat to approx. 70°C until everything has melted.

Add B to A, stir in, and homogenize for 30 seconds (avoid air bubbles).

Cool down to 40°C while stirring occasionally.

Add C and stir in.

Homogenize briefly once more (avoid air bubbles).

Adjust the pH value to approx. 5.2.

 

TIP:

When cooling down, ensure the emulsion does not cool too quickly and stir it frequently. Especially when the fat phase consists of a high proportion of consistency agents and waxes, you should not cool it in a cold water bath, otherwise the waxes may crystallize at the edge of the beaker. As the emulsion gains consistency, avoid using a mixer to incorporate air, as it cannot be removed afterwards.


Leave a comment

Please note, comments must be approved before they are published


FAQ: Frequently Asked Questions about Hand Balm "Protection"

Was macht den Hand Balm „Protection“ besonders?

Der Handbalsam hat viel Feuchtigkeit, wenig Öl und einen hohen Wachsanteil. Er bildet rasch einen schützenden, unfettigen Film – ideal bei häufigem Händewaschen.

Welche Rohstoffe bilden den Schutzfilm?

Careblend Supreme haftet durch seine kationische Eigenschaft gut auf der Haut. Hydrolysiertes Sonnenblumenwachs und SoftEster bilden einen flexiblen Film, Niacinamid unterstützt die Hautbarriere.

Wie aufwendig ist die Herstellung?

Das Rezept ist mittelschwer (zwei Sterne) und dauert etwa 40 Minuten. Beide Phasen werden auf etwa 70 Grad erhitzt, dann homogenisierst du 30 Sekunden, kühlst auf 40 Grad ab und stellst den pH-Wert auf etwa 5,2 ein.

Worauf muss ich beim Abkühlen achten?

Lass den Balsam langsam abkühlen und rühre immer wieder – nicht im kalten Wasserbad, sonst kristallisieren die Wachse am Becherrand aus. Sobald er Konsistenz bekommt, vermeide es, mit dem Mixer Luft einzuschlagen.